The transfer type drying oven [ELNAS-250] realizes automation from the application of moisture-proof agent to drying.

 
There are many sites where the drying process after applying a moisture-proof agent (HumiSeal, etc.) is done naturally.
 
Recently, however, many sites are considering switching from conventional natural drying to automation in order to improve production efficiency. Become.
 
Antom’s transport-type drying furnace ELNAS-250 is specialized only for drying solvents, and its major feature is that the height of the transport section (part effective height) secures a clearance of 100 mm both above and below.
 
Therefore, it is possible to put the board in the drying oven as it is, even if the solvent is applied to the board with tall parts mounted on it.
 
In addition, the time required for drying varies depending on the solvent, so the transport speed can be adjusted from 0.5 to 2.0 m/min to accommodate a wide range of drying, from short-time drying to drying that takes a certain amount of time.
 
This solves problems such as drying in a short time and production takt time.
 
In addition, the exhaust duct can be used to recover the unique odors of moisture-proof agents such as HumiSeal, which are often used.
 
Please check the detailed specifications of the transport type drying oven [ELNAS-250] from the following page.
 

Compact transport type drying dedicated model [ELNAS-250]